ROLLER BEARINGS
STAR TING GEAR
ONE-- WAY CLUTCH
FLYWHEEL
ENGINE DISASSEMBLY / ASSEMBLY
4.56
2004 Four Stroke PWC Service Manual
Engine Assembly
21. Apply a generous amount of engine oil to thecrankshaft
end and roller bearings.
22. Install the roller bearing, starting gear, and flywheel key
into end of crankshaft.
23. Install the flywheel on to the crankshaft. V erify flywheel
fits over key.
24. Apply Loctitet 262 to flywheel bolt, and install.
25. Install two of the PTO coupler bolts into the PTO--end
of the crankshaft. Have an assistant place a pry bar
across these two bolts to prevent the crankshaft from
rotating.
26. Tighten flywheel bolt to specification.
To Next Page
Loading...
Need help?
General