45
OPERATION
Break-In Period
The break--in period for your new Polaris ATV i s the first ten hours of
operation, or the time it takes to use the first two full tanks of gasoline.
No single action on your part is as important as following the
procedures for a proper break--in. Careful treatment of a new engine
and drive components will result in more efficient performance and
longer life for these components.
CAUTION
Excessive heat build-up during the first three hours of operation
will damage close-fitted engine parts. Do not operate at full
throttle or high speeds for extended periods during the first three
hours of use.
Engine and Drivetrain Break-in
1. Fill the fuel tanks with gasoline. See page 33.
2. Check the oil reservoir level on the dipstick. See page 70. Add
oil i f necessary to maintain the level between the safe and add
marks.
3. Drive slowly at first. Select an open area t hat allows room to
familiarize yourself with vehicle operation and handling.
4. Vary the throttle positions. Do not operate at sustained idle.
5. Perform regular checks on fluid levels, controls and areas outlined
on the daily pre-ride inspection checklist. See page 46.
6. Pull only light loads.
7. During the break-in period, change both the oil and the filter at 20
hours or one month.
PVT Break-in (Clutches/Belt)
A proper break-in of the clutches and drive belt will ensure a longer
life and better performance. Break in the clutches and belt by operating
at slower speeds during the break-in period as recommended. Pull only
light loads. Avoid aggressive acceleration and high speed operation
during the break-in period
To Next Page
Loading...
