25
PRE-OPERATION INSPECTION
Note: Always perform the recommended pre-operation inspections before each
use. Always perform the inspections at the beginning of a project and
when removing the generator from storage.
Failure to perform the recommended pre-operation inspections could
result in minor or moderate injury or property damage. When inspection
reveals the need for adjustment, replacement, or repair, perform service
promptly.
Pre-Operation Checklist
Open the service door to expose the generator inner components. See
page 46.
Engine Oil
Perform “Oil Level Inspection” (see page 49). Add oil as needed.
Fuel Line
Petrol is highly flammable and explosive and can cause serious injury.
Stop the engine and keep heat, sparks, and flame away. Handle fuel only
outdoors. Wipe up spills immediately.
Inspect the fuel hose for cracks or damage. Replace as needed.
Fuel Level
Check the fuel level and refuel as needed. See page 26.
Exhaust System
If the engine has been running, the muffler will be very hot. Allow the
muffler to cool before servicing.
Inspect the exhaust system for leakage. Tighten or replace the gasket as
needed.
Carburetor
Inspect the choke lever operation.
Starting System
Inspect the recoil starter operation. Verify the starter recoil grip
functions properly.
Air Filters
Inspect the air filters. Clean or replace as needed. See page 25.
To Next Page
Loading...
Need help?
General
