127
MAINTENANCE AND LUBRICATION
Spark Arrestor Clean-Out
Periodically clean the spark arrestor to remove accumulate d carbon.
1. Remove the three screws (1) and remove the arrestor (2)
from the end of the muffler.
2. Use a non-synthetic brush to clean the arrestor
screen (3). A synthetic brush m ay melt if
components are warm. If necessary, blow debris
from t he screen with compressed air.
3. Inspect the screen for wear and damage. Replace if
necessary.
4. Remove and inspect the gasket. Replace if worn or
damaged.
5. Reinstall the gasket and arrestor.
6. Torque screws to 50 in. l bs. (5.6 Nm).
1
2
3
To Next Page
Loading...
