BREAK-IN PERIOD
The break-in period consists of the first 25 hours of operation. Careful treatment
of a new engine and drive components will result in more efficient performance
and longer life for these components.
• Drive vehicle slowly at first while varying the throttle position. Do not operate
at sustained idle.
• Perform regular checks on fluid levels and other areas outlined on the daily
pre-ride inspection checklist.
• Change both the engine oil and filter after 25 hours or one month.
MAINTENANCE INTERVALS
The maintenance interval charts list required maintenance and inspection based
on vehicle hours / miles. Each table states a service that corresponds to the
hour / mile chart below. Some items or components may need to be serviced
more often due to severe use, such as operation in water, extreme
temperatures, or under severe loads.
HOUR / MILEAGE SERVICE
First 25 hours / 200 miles (320 km) Break-In Service — Perform the 200
Hour Check List (Table 2)
Every 50 hours / 500 miles (800 km)
thereafter
See Table 1
Every 100 hours / 1000 miles (1600
km) thereafter
See Table 2
Every 200 hours / 2000 miles (3200
km) thereafter
See Table 3
98
MAINTENANCE
To Next Page
Loading...
Need help?
General
