FINAL DRIVE
7.12
Roll Pin Removal Tool (PN 2872608)
NOTE: Remove the drive shaft floor cover to help
align the roll pin removal tool to the roll pin for removal.
The drive shaft can be removed through the floor
covering.
U-JOINT DISASSEMBLY
CAUTION: Always wear eye protection.
1. Remove internal or external snap ring from all
bearing caps.
NOTE: If yoke or bearing is removed, cross bearing
must be replaced. Note orientation of grease fitting
and mark inner and outer yoke for correct
re-positioning during installation.
2. Support inner yoke as shown and drive outer yoke
down (bearing cap out) with a soft face hammer.
3. Support U-joint in vise as shown and drive inner
yoke down to remove remaining bearing caps.
To Next Page
Loading...
