FINAL DRIVE
7.27
MID DRIVE HUB EXPLODED VIEW (6X6)
MID DRIVE SHAFT REMOVAL
(6X6)
1. Repeat Steps 1--6 in the “MID DRIVE BEARING
CARRIER/HUB REMOVAL” section.
2. Slide the middle axle out of the bearing carrier by
pulling the bearing carrier assembly outward and
down.
3. Remove the roll pin from the middle axle (C), using
the Roll Pin Removal Tool (PN 2872608). The
spring pin secures the yolk of the middle axle to
the middle gearcase (D) output shaft.
NOTE: To ease the removal of the roll pin from the
middle axle and middle gearcase output shaft,
remove the dump box from the frame. Refer to
Chapter 5.
C
Roll Pin Tool
D
HUB
SNAP RING
BEARING
BEARING CARRIER
BUSHING
MID LOWER A--ARM
BUSHING
SHAFT
MID DRIVE AXLE
MID UPPER A--ARM
BUSHING
To Next Page
Loading...
