FINAL DRIVE
7.41
REAR HUB INSPECTION
1. Support machine securely with rear wheels
elevated.
2. Grasp wheel/hub and check for movement.
3. If movement is detected, inspect hub, hub nut
torque and bearing condition and correct as
necessary.
REAR DIFFERENTIAL
REMOV
AL/INSPECTION
1. Jack up vehicle and support on frame and swing
are.
2. Remove rear wheels.
3. Remove the brake caliper . Suspend the brake
caliper
from the frame with wire (both sides).
CAUTION:
Serious injury could occur if machine tips or falls.
Brake Caliper
4. Remove the hub cover, cotter pin, spindle nut and
washer (both sides).
5. Pull the hub of f of the axle.
NOTE: ONLY 2x4 and 4x4 models have an
actuator on the rear gearcase. Steps 6--8 apply
only to the 2x4 and 4x4 models. The 6x6 model
does not have the rear gearcase actuator.
6. Remove the cotter pin from the rear gearcase
bellcrank. Lift the actuator loose from the bell
crank.
7. Loosen the jam nuts that secure the actuator to the
bracket. Place the actuator to the side.
8. Remove the hose clamp from the rear gearcase
breather hose. Remove the breather hose.
9. Remove the bottom shock bolts and shocks (both
sides).
To Next Page
Loading...
