FINAL DRIVE
7.47
15. Install the tire and four wheel nuts. Torque the
castle nut and the wheel nuts to specifications.
Rear Spindle Nut Torque
110 ft. lbs. (149 Nm)
Rear Wheel Nut Torque
35 ft. lbs. (47 Nm)
16. Install a new cotter pin. T ighten nut slightly to align
holes if required. Install the hub cap.
REAR AXLE BEARING
REMOVAL/INSTALLA
TION
1. For rear axle bearing removal, see Page 7.44 .
Axle
Retaining Ring
Bearing
Axle Tube
REAR DIFFERENTIAL
REMOV
AL
1. Refer to Steps 1--17 in the REAR DIFFERENTIAL
REMOVAL/INSPECTION section on Page
7.41--7.43 for the removal of the rear gearcase.
REAR DIFFERENTIAL
DISASSEMBLY (2X4 &
4X4)
1. Drain and properly dispose of used oil.
2. Remove the gearcase housing cover bolts and the
differential housing cover.
3. Remove the shim and O--ring from the housing
cover.
O--Ring
Shim
To Next Page
Loading...
