FINAL DRIVE
7.49
Rear Differential Actuator Removal
8. With two small prybars or suitable tools, pry up and
outward on the actuator arm. Lift the actuator arm
out of the differential cover . A retaining ring
secures the actuator assembly in the differential
cover.
Actuator Arm
9. Inspect the actuator assembly and replace parts as
needed. Refer to you parts manual for new parts.
NOTE: The actuator assembly can be taken apart,
refer to the exploded view at the end of this section for
a parts breakdown.
O--ring
Seal
Retaining Ring
Spring &
Retaining
Ring
Cam
REAR DIFFERENTIAL
ASSEMBLY (2X4 &
4X4)
1. Inspect the pinion shaft bushing for wear.
2. Replace all O--rings, seals, and worn components.
To Next Page
Loading...
