3. Disconnect the harness from the bulb. Be sure to pull on the connector, not
on the wiring.
4. Remove the rubber bulb cover, release the bulb protection spring
q
and
remove the bulb from the headlight housing.
5. Install the new bulb into the housing.
NOTE
Make sure the tab on the bulb locates properly in the housing.
6. Make sure the bulb catches on the protection spring. Reinstall the rubber
bulb cover.
7. Install the harness onto the new High/Low bulb and install the hood.
114
MAINTENANCE
Downloaded from ManualsNet.com search engine
To Next Page
Loading...
