HITCH REMOVAL / INSTALLATION
1. To remove the hitch, remove the cotter pin
q
and hitch pin
w
. Remove the
hitch, then reinstall the hitch pin
w
and secure the cotter pin
q
.
2. To install the hitch, remove the cotter pin
q
from the hitch pin and remove
the hitch pin
w
.
3. Install the hitch to the receiver.
4. Reinstall the hitch pin (from the left side of the hitch) through the bore of both
the receiver and the hitch.
5. Reinstall the cotter pin. Make sure the hitch assembly is secure at that the
cotter pin is properly engaged over the hitch pin.
7-WAY TRAILER CONNECTOR
The 7-way trailer connector
q
installed on your vehicle meets the requirements
of European standard ISO 1724.
This connector uses all 7 pins on newer model trailers. An older model trailer
may not be compatible with this connector.
Improper electrical wiring changes can result in damage to both vehicle and
trailer components. When in doubt about your trailer connection, please contact
a qualified towbar specialist for assistance.
42
FEATURES AND CONTROLS
Downloaded from ManualsNet.com search engine
To Next Page
Loading...
Need help?
General
