SYMPTOM POSSIBLE
REASON
LED
STATUS
ACTION TO RESOLVE
ISSUE
EPS (Electronic
Power Steering)
warning lamp (in
vehicle
instrument
cluster)
illuminating
when Plug-In is
connected to
vehicle
Potential
incompati-
ble Plug-In
device
(baud rate)
Warning
lamps will
be
illuminated
in vehicle
gauge
cluster.
GPS LED:
N/A
Cellular
LED: N/A
1. Turn the key to ignition
OFF position and
disconnect Plug-In.
2. With the Plug-In
disconnected, turn key to
ignition ON and start the
vehicle and see if EPS
fault appears.
If the EPS fault appears, refer
to the Owner’s Manual for
EPS Warning Lamp details,
and contact your dealer if
repairs are required.
If EPS fault does not appear,
the Plug-In installed on the
vehicle is not compatible,
replace with the correct
Plug-In for the vehicle.
Refer to ridecommand.
polaris.com/ridecommand+
for vehicle compatibility and
accessory kit fit.
If you are unable to resolve the issue, reach out to ridecommand.polaris.
com/support or our Customer Support Center via phone at 1 (800) 765-2747 for
RIDE COMMAND/RIDE COMMAND+ questions.
24
RIDE COMMAND+ TROUBLESHOOTING
To Next Page
Loading...
Need help?
General
