112
MAINTENANCE
Suspension Settings
(RZR S Premium Models and RZR 4)
Front/Rear Spring Preload
The factory setting is appropriate
for nearly all riding conditions.
Since the vehicle is equipped with
full skid plates, adjustment is not
necessary.
If desired, the suspension may be
adjusted to maintain vehicle
clearance height when carrying
loads. Please see your POLARIS
dealer for the tool required to make
suspension adjustments. Elevate the
vehicle slightly for easier
adjustment.
Follow these guidelines if you make adjustments to this suspension.
• Always return the suspension to the factory setting after the load is removed
from the vehicle. The increased suspension height will negatively impact vehi-
cle stability when operating without a load.
• Always apply the same adjustment setting to all four wheels.
• Do not increase the spring preload by more than one inch (25.4 mm) over the
factory setting.
Factory Preload Settings
RZR S Premium Front 4.34” (110.2 mm)
RZR S Premium Rear 5.15” (130.8 mm)
RZR 4 Base Front 4.5” (114.3 mm)
RZR 4 Base Rear 5.29” (134.4 mm)
RZR 4 Premium Front 4.31” (109.5 mm)
RZR 4 Premium Rear 4.99” (126.7 mm)
Preload Setting
Measurement
To Next Page
Loading...
Need help?
General
