POSSIBLE CAUSE SOLUTION
Clogged intake pre-filter Inspect and clean (with soapy water)
or replace
Other mechanical failure Your POLARIS dealer can assist.
Overheated engine Clean radiator screen and core, clean
engine exterior, check coolant level.
Your POLARIS dealer can assist.
Loose intake system connections Inspect connections, tighten or
replace as needed
Overheated intake air system Inspect water lines for leaks or kinks,
repair or replace as needed
DIAGNOSTIC DISPLAY CODE DEFINITIONS
Open Load: There is a break in the wires that lead to the item listed in the chart
(injector, fuel pump, etc.), or the item has failed.
Short-to-Ground: The wire is shorted to ground between the electronic control
unit and the item listed in the chart.
Shorted Load: The wires leading to the item listed in the chart are shorted
together, or the item has shorted internally.
Short-to-Battery: The wire leading from the item listed in the chart to the
electronic control unit is shorted to a wire at battery voltage.
DIAGNOSTIC CODES
CONDITION SPN FMI
Engine Control Module
Manifold Absolute Pressure/Barometric Pressure
Sensor Circuit Low
102 4
Accelerator Position 2 Voltage Too Low 29 4
System Voltage Low 168 4
Gear Shift Position Circuit "A" Low 523 4
Engine Coolant Temperature Sensor 1 Circuit High 110 3
Engine Temperature Sensor Engine Overheat
Shutdown
110 0
159
TROUBLESHOOTING
To Next Page
Loading...
Need help?
General
