INSPECTING THE HARNESS
WARNING
Failure to perform regular inspection can reduce the effectiveness of the seat
belt during a crash and could result in serious injury or death.
Before each ride, perform the following inspection:
1. Inspect belt fabric on entire system for cuts, fraying, extreme or unusual
wear. Most common areas of belt wear include the buckle/ tongue area, the
shoulder guide area and any place where the belt makes contact with vehicle
or seat.
Corrective Action: Replace entire belt system
2. Inspect buckle for proper operation by inserting tongue and listening for an
audible click. Verify buckle is not damaged, cracked or broken.
Corrective Action: Replace entire belt system
3. Inspect electrical wires (optional component). Internal cable wires must not
be exposed, frayed or broken.
Corrective Action: Replace entire belt system
43
FEATURES AND CONTROLS
To Next Page
Loading...
