4. Using an oil filter wrench, turn the filter
w
counter-clock- wise to remove it.
5. Using a clean dry cloth, clean the filter sealing surface on the crankcase.
6. Lubricate the o-ring on the new filter with a film of fresh engine oil. Check to
make sure the o-ring is in good condition.
7. Install the new filter and turn by hand until the filter gasket contacts the
sealing surface, then turn an additional 3/4 turn.
8. Reinstall the crankcase drain plug with a new sealing washer. Torque to 12 ft.
lbs. (16 Nm).
NOTE
The sealing surface on the drain plug should be clean and free of burns, nicks,
or scratches.
104
MAINTENANCE
To Next Page
Loading...
