SWITCHES
IGNITION SWITCH
The ignition switch
q
is a four-
position, key-operated switch. Use the
ignition switch to start the engine. See
page 50 for engine starting
procedures.
POSITION FUNCTION
OFF
The engine is off. Electrical circuits are off, except
accessory 12V.
ACCESSORY
The engine is off. Provides power to the accessory
terminal block.
ON
Electrical circuits are on. Electrical equipment can be
used.
START
Turn the key to the START position to engage the
electric starter. The key returns to the ON position
when released.
The key can be removed from the switch when it is in the OFF position.
HEADLIGHT SWITCH
The ignition switch key must be in the ON/RUN
position to operate the headlights. Press the top of the
switch to place the headlights on high beam. Move the
switch to the center position to place the headlights on
low beam. Press the bottom of the switch to turn off the
headlights.
If the headlight switch is ON when the ignition switch is
turned off, the lights will remain on for approximately
20 seconds.
31
FEATURES AND CONTROLS
To Next Page
Loading...
