SEAT BELT INSPECTION
Inspect all seat belts for proper operation before each use of the vehicle.
1. Push the latch plate into the buckle until it clicks. The latch plate must slide
smoothly into the buckle. A click indicates that it's securely latched.
2. Push the red release latch in the middle of the buckle to make sure it
releases freely.
3. Pull each seat belt completely out and inspect the full length for any damage,
including cuts, wear, fraying or stiffness. If any damage is found, or if the seat
belt does not operate properly, have the seat belt system checked and/or
replaced by an authorized dealer.
4. To clean dirt or debris from the seat belts, sponge the straps with mild soap
and water. Do not use bleach, dye or household detergents. Rinse the entire
length of the belt webbing. Use a garden hose to flush out the retractor and
latch housings regularly.
SEAT ADJUSTMENTS
WARNING
Before operating the vehicle, always push down on the seat backs to ensure
the latches are secure.
On seats equipped with an adjustment
lever
q
under the front edge of the
seat, pull the lever to the left. Slide the
seat forward or rearward to the desired
position. Release the lever. The seat
will lock into the new position.
SEAT REMOVAL
To remove the seat, do the following:
1. Pull up on the seat latch lever located under the rear edge of the seat.
2. Tilt the seat forward.
3. Lift the seat upward to remove it from the vehicle.
36
FEATURES AND CONTROLS
To Next Page
Loading...
