DEMAND DRIVE FLUID CHANGE
The demand drive drain plug
q
is located on the bottom of the gearcase.
1. Remove the fill plug.
2. Place a drain pan under the drain plug.
3. Remove the drain plug. Allow the fluid to drain completely.
4. Clean the drain plug.
5. Reinstall the drain plug. Torque to specification (listed in the Gearcase
Specification Chart of this manual).
6. Add the recommended fluid (listed in the Gearcase Specification Chart) to
the bottom thread of the fill plug hole.
7. Reinstall the fill plug. Torque to specification listed in the Gearcase
Specification Chart).
8. Check for leaks. Discard used fluid properly.
148
MAINTENANCE
To Next Page
Loading...
