HEADLIGHT SWITCH
Use the headlight switch to turn the lights on and off
and to change the lights from high beam to low beam.
The ignition switch must be in the ON position to
operate the headlights.
Press the top of the rocker switch toward the dash to
place the headlights on high beam
q
. Move the rocker
switch to the center position to place the headlights on
low beam
w
. Press the bottom of the rocker switch to
turn off the headlights.
If the headlight switch is ON when the ignition switch is turned off, the lights will
remain on for approximately 30 seconds.
ELECTRONIC POWER STEERING (EPS)
Electronic power steering (if equipped) engages when the ignition key is turned
to the ON position. EPS remains engaged whether the vehicle is moving or idle.
The EPS warning indicator briefly illuminates when the key is turned to the ON
position. See the Instrument Cluster section for details.
To conserve battery power, the EPS will shut down 5 minutes after the engine is
stopped if the key remains in the ON position. The EPS warning indicator will
illuminate to indicate the EPS has shut down.
If the light remains on after starting the engine, the EPS system is inoperative.
See your POLARIS dealer, or other qualified person, as soon as possible for
repair. Continued operation could result in permanent damage to the EPS unit
and increased steering effort.
AUXILIARY OUTLETS
The vehicle is equipped with one or more 12-volt
accessory outlets. One outlet is on the dash, a second
outlet (if equipped) is in the rear passenger area. Use
the outlets to power an auxiliary light or other optional
accessories. For service, the dash outlet connection is
under the dash. The rear outlet connection is under
the rear passenger seats.
32
FEATURES AND CONTROLS
To Next Page
Loading...
