VEHICLE IMMERSION
NOTICE
If your vehicle becomes immersed, major engine damage can result if the
machine is not thoroughly inspected. Take the vehicle in for service before
starting the engine. Your POLARIS dealer or other qualified person can
provide this service.
If it’s impossible to take your vehicle to a dealer before starting it, follow the
steps outlined below.
1. Move the vehicle to dry land.
2. Check the air box. If water is present, dry the air box and replace the filter
with a new filter.
3. Remove the fuse/relay center cover. Allow any moisture to dry, then reinstall
the cover.
4. Dry the spark plug wells with a clean cloth, then remove the spark plugs.
5. Turn the engine over several times.
6. Dry the spark plugs and reinstall them, or install new plugs.
7. Attempt to start the engine. If necessary, repeat the drying procedure.
8. Take the vehicle in for service as soon as possible, whether you succeed in
starting it or not. Your POLARIS dealer or other qualified person can provide
the required service.
9. If water has been ingested into the PVT follow the procedure on page 134 for
drying.
STEERING WHEEL INSPECTION
Check the steering wheel for specified freeplay and smooth operation at the
intervals outlined in the Periodic Maintenance Chart.
1. Position the vehicle on level ground.
2. Lightly turn the steering wheel left and right.
3. There should be 0.8-1.0 in (20-25 mm) of freeplay.
4. If there is excessive freeplay or strange noises, or if the steering feels rough
or “catchy,” have the steering system inspected by an authorized POLARIS
dealer or other qualified personnel.
148
MAINTENANCE
To Next Page
Loading...
Need help?
General
