PASSCODE CHANGE - RIDE COMMAND DISPLAY
Perform the following steps to change the vehicle passcode.
NOTICE
If a user passcode has not already been set, the master passcode must be
entered.
1. Go to ‘Settings’ by touching the Slingshot logo at the top of the screen and
then touching the ALL SETTINGS button in the lower-right corner.
2. Touch the ‘Vehicle’ tab on the left side, and then the “Passcode Unlock” line.
3. Touch the “Change Passcode” button.
4. Follow the screen prompts to edit the vehicle passcode.
If new passcode verification is successful, the Ride Command screen will
display “New code accepted”. The new user passcode may now be used to
unlock vehicle operation.
If the new passcode verification is unsuccessful, the Ride Command screen will
display “Enter Current Code” and you will need to re-enter the new passcode.
If the second verification attempt is unsuccessful, the Ride Command screen will
display “New codes did not match”, and will prompt you to enter and verify a new
passcode again.
61
FEATURES AND CONTROLS
To Next Page
Loading...
Need help?
General
