PASSCODES USING THE INSTRUMENT CLUSTER
If the vehicle is not equipped with a Ride Command display, the instrument
cluster is used to enter/edit passcodes if the key fob is not within range.
PASSCODE ENTRY - INSTRUMENT CLUSTER
If the key fob is not found by the Vehicle Control Module (VCM), the instrument
cluster will prompt the operator to enter a passcode to unlock vehicle operation.
1. "ENTER PASSCODE" will appear on the screen.
2. Use the ‘up’ and ‘down’ toggle buttons to increment through 0-9 for the first
(left-most) digit of your user passcode or the master passcode.
NOTICE
If a user passcode has not been set, the master passcode must be entered.
3. Push the MODE button to accept the current number, then toggle up/down to
select the next number.
4. Repeat this procedure to enter the remaining three numbers.
If the passcode entry is correct, the vehicle can be operated as normal.
If the passcode is incorrect, “WRONG PASSCODE” will appear on the screen,
and you will be prompted to re-enter the passcode. If over five unsuccessful
entry attempts are made, the screen will show “ATTEMPTS EXCEEDED”. This
will require an ignition cycle before further attempts can be made.
62
FEATURES AND CONTROLS
To Next Page
Loading...
Need help?
General
