PASSCODE CHANGE - INSTRUMENT CLUSTER
Perform the following steps to change the vehicle passcode.
1. Press and hold the MODE button. This will bring you to the Settings page.
2. Use the ‘up’ and ‘down’ toggle buttons to scroll until the screen displays
“CHANGE PASSCODE”. Then press the MODE button to select.
3. The screen will display “ENTER CURRENT PASSCODE”. Use the ‘up’ and
‘down’ toggle buttons to increment through 0-9 for the first (left-most) digit of
your current user passcode or the master passcode.
NOTICE
If a user passcode has not been set, the master passcode must be entered.
4. Push the MODE button to accept the current number, then toggle up/down to
select the next number.
5. Repeat the procedure to enter the remaining three numbers.
6. If the passcode is accepted, the screen will display “ENTER NEW
PASSCODE”.
7. Enter a new passcode using the procedure outlined in steps 3-5.
8. Once complete, the screen will display “VERIFY NEW PASSCODE”. Re-
enter the same new passcode.
If the two passcode entries match, the screen will display “PASSCODE
CHANGE SUCCESSFUL”. The new passcode may now be used to unlock
vehicle operation.
If the two passcode entries do not match, the screen will display “WRONG
PASSCODE”, and will prompt you to make another attempt.
If the second attempt is unsuccessful, the screen will display “PASSCODES DO
NOT MATCH” and will prompt you to “ENTER NEW PASSCODE” again
(restarting the process at step 6 above).
63
FEATURES AND CONTROLS
To Next Page
Loading...
Need help?
General
