REAR SUSPENSION
1. Check rear shock absorber movement to ensure the correct amount of
suspension travel and ground clearance. Refer to the Specifications chapter
for details.
WARNING
Inadequate ground clearance could result in components contacting the
ground, causing loss of control and serious injury or death. Always ensure
ground clearance is at specification.
DRIVE BELT
1. Check the drive belt
q
teeth for
stones or other debris.
2. Inspect drive belt condition. If you
discover cracks, broken teeth or
frayed edges, replace the drive
belt before riding. Refer to the
SLINGSHOT Service Manual , or
an authorized dealer can assist.
FASTENERS
1. Inspect the entire vehicle chassis and engine for loose, damaged or missing
fasteners. Tighten loose fasteners to the proper torque.
NOTICE
Refer to the specifications section of this manual or the service manual for
fastener torque values. If needed, your dealer can assist.
2. Always replace stripped, damaged or broken fasteners before riding.
POLARIS recommends genuine SLINGSHOT fasteners of equal size and
strength.
68
PRE-RIDE INSPECTIONS
To Next Page
Loading...
Need help?
General
