EXTENDED
STORAGE
AND
WIINTEWIZAT%ON
Watercraft
Engine Fogging Procedure
Important:
Failure to perform the following preventive maintenance can result in
serious engine corrosion during off season or extended storage. In order to pre-
vent rust and corrosion on internal engine parts (i.e. crankshaft, bearings, pistons,
rings, cylinder walls). Polaris highly recommends the use of Polaris fogging oil (PN
2870791) as a recommended storage procedure.
The fogging oil coats all internal parts for prevention of rust and corrosion, which
in turn will extend the life of the engine.
1. Loosen the two bolts holding the air intake cover
(A)
and remove the cover.
2.
Remove the filter element.
3.
Start the engine and
spray Polaris fogging oil
into each carburetor
throat to ensure that all
internal parts are
properly coated. Spray
fogging oil for two to
three seconds in each
carburetor throat and
repeat until the engine is
flooded with fogging oil.
Then stop the engine
immediately.
Never operate the engine for more than
15
seconds while the watercraft is out of
the water. The engine may overheat and seize.
4.
Reinstall filter element and air intake cover.
To Next Page
Loading...
Need help?
General
