MAINTENANCE
Battery InstalPation
Install the battery vent tube. It
must be free from obstructions
and securely installed. If not,
battery gases could
accumulate and cause an
explosion. Avoid skin contact
with electrolyte, severe burns
could result.
Always connect battery cables in the order specified. Red (positive) cable first,
black (negative) cable last.
3.
First connect and tighten the
red (positive) cable.
1.
Install the battery in its holder.
Top View of Battery
-
Black
(-)
Red
(+)
---
--
4.
Second connect and tighten
the black (negative) cable.
5.
Apply dielectric grease
PN
2871 066 to each cable.
6.
Reinstall the battery cover and electrical box over the battery and reconnect
straps.
7.
Verify that cables are properly routed.
8.
Verify that the vent hose is not kinked.
Battery Storage
1.
Remove the battery. Clean the casing and terminals with baking soda and
water (one tablespoon of baking soda to one cup water). Apply dielectric
grease
PN
2871 066 or petroleum jelly to battery terminals and all exposed
cable connectors.
2.
Top off the battery with distilled water and charge it to a specific gravity of
1.26.
Recharge monthly as required to prevent battery discharge and sulfating.
3.
Store the battery in a cool, dry place out of direct sunlight. Do not allow it to
freeze.
To Next Page
Loading...
Need help?
General
