TRANSMISSION
8.12
TRANSMISSION REASSEMBLY CONT’D
Pinion Retainer Plate
6--12 ft. lbs. (8--16 Nm)
Bolt Torque:
9. Install the a new needle bearing, the 24T reverse
sprocket, washer, and a new snap ring. Install the
shift dogs and wave spring. Install the washer, a
new needle bearing and the high gear. Install the
press fit gear and ball bearing.
NOTE: Install a new snap ring at this time. When
installing the new snap ring, open the the snap ring
just far enough to go over the shaft, to avoid stressing
the snap ring. If the snap ring is over--stressed, it
could come off the shaft and cause internal damage
to the transmission.
10. Slide the reverse shaft assembly through the
silent chain.
11. Install a new needle bearing, the low gear, the
thrustwasher and the snap ring. Use of a new
snap ring is recommended.
12. Install the engagement dogs, wave springs, and
bearing.
13. Install the ball bearing onto the end of the input
shaft.
14. As the engagement dogs are installed onto the
shaft, place the wave springs into the spring
groove. Keep the spring in place while the fork is
being installed on the shaft and while placing the
shafts into the case.
Enfocus Software - Customer Support
To Next Page
Loading...
