TRANSMISSION
8.15
TRANSMISSION REASSEMBLY CONT’D
28. Install the park lockout assembly. Torque park
lockout to 12 -- 14 ft. lbs. (16--19 Nm).
29. Apply Crankcase Sealant (PN 2871557) onto the
cover and case mating surfaces. Install the cover
and torque the cover bolts to 6--12 ft. lbs. (12--16
Nm).
Install Cover and Bolts
Park Lockout Cover Bolt Torque:
6--12 ft. lbs. (12--16 Nm)
30. Install a new bellcrank onto the shift shaft. Note
the keyed spline on the bellcrank and shaft.
Install the washer and nut. Torque the bellcrank
nut to 12--18 ft. lbs. (16--24 Nm).
Bellcrank Nut Torque:
12--18 ft. lbs. (16--24 Nm)
31. Install the shift switch. Install the retaining clip.
Hook up the switch harness and reconnect the
lockout plunger spring.
NOTE: Rotate the bellcrank to line the flat side of the
switch up to the flat side of the shaft.
32. Install transmission and add Polaris Premium
Synthetic Gear Case Lubricant (PN 2871477)in
the recommended amount. Refer to Maintenance
Chapter 2 for more information.
Enfocus Software - Customer Support
To Next Page
Loading...
