87
MAINTENANCE
Brakes
The front and rear brakes are hydraulic disc brakes, activated by apply-
ing the foot brake. The handlebar brake is also hydraulic. Both brake
systems are self-adjusting.
Brake Inspections
Perform the following checks to keep the brake systems in good operat-
ing condition. Check more often if brakes are used heavily under normal
operation.
1. Always keep brake fluid at an adequate
level. See page 85.
2. Check the brake systems regularly for
fluid leaks.
3. Check the brakes for excessive travel or
spongy feel.
4. Check the friction pads for wear, damage
and looseness. Replace the pads when
the friction material is worn to 1 mm.
5. Check the security and surface condition
of the disc. Clean any grease using a recommended brake cleaner or
alcohol. Do not use spray lubricants or other petroleum-based prod-
ucts. If you discover any damage (cracks, excessive corrosion,
warping) see your dealer for service before operating.
1 mm
To Next Page
Loading...
