102
MAINTENANCE AND LUBRICATION
Filter Systems
Cleaning the Main Filter
NOTE: It is advisable to replace the filter when it is dirty. However,
in an emergency it is permissible to clean the main filter if you observe
the following practices.
1. Never immerse the filter in water since dirt can be transferred to
the clean air side of the filter.
2. If compressed air is used never exceed a pressure of 40 PSI.
Always use a dispersion type nozzle to prevent filter damage and
clean from the inside to the outside.
NOTE: Replace the air filter every 50 hours, and possibly more often
in very dirty conditions.
Air Filter Service - 4 Cycle
1. Remove seat.
2. Release clips and remove
cover.
3. Loosen clamp and remove
filter
4. Remove fabric type
pre-filter (1) from main
filter (2). Wash pre-filter
in soapy water and dry it.
5. Reinstall pre-filter over
main filter. Replace main
filter as required.
6. Reinstall filter into air box
and tighten clamp. Do not
over tighten clamp or filter
damage may occur.
2
1
To Next Page
Loading...
Need help?
General
