123
MAINTENANCE AND LUBRICATION
Spark Arrestor (cont.)
4. If particles are still
suspected to be in the
muffler, back the
machine onto an
incline so the rear of
the machine is one foot
higher than the front.
Set the parking brake
and block the wheels.
Make sure the machine
is in neutral and repeat steps 2 and 3.
5. If particles are still suspected to be in the muffler, drive the
machine onto the incline so the front of the machine is one foot
higher than the rear. Set the parking brake and block the wheels.
Make sure the machine is in neutral and repeat steps 2 and 3.
6. Repeat steps 2 through 5 until no more particles are expelled when
the engine is revved.
7. Stop the engine and allow the arrestor to cool.
8. Reinstall the arrestor plug.
1
To Next Page
Loading...
