133
MAINTENANCE AND LUBRICATION
Cleaning and Storage
* Fog The Engine - Remove the spark plug and add 2-3 tablespoons of
Premium 4 Synthetic 0W40 engine oil. To access the plug hole use a
section of clear 1/4″ hose and a small plastic squeeze bottle filled with the
pre-measured amount of oil. Install the spark plug and pull the engine
over slowly with the recoil starter. Oil will be forced in and around the
piston rings and ring lands, coating the cylinder with a protective film of
fresh oil.
Battery Maintenance - Remove the battery and add distilled water as
required to the proper level. Do not use tap water which may contain
minerals that reduce battery life. Apply Polaris Di-Electric Grease to
the terminal bolts and terminals. Charge the battery at 1.4 amps or less
until specific gravity of each cell is 1.265 or greater. Store the battery
in a cool, dry, place. Charge can be maintained easily by using Polaris
Battery Tender charger (PN 2871076) or by charging about once a
month to make up for normal self-discharge. Battery Tender can be
left connected during the storage period, and will automatically charge
the battery if the voltage drops below a pre-determined point. The only
thing you need to do is check the fluid level once a month.
Engine Anti-Freeze - Test engine coolant strength and change if
necessary. Coolant should be replaced every 2 years.
Storage Area/Covers - Set tire pressure and safely support the ATV
with the tires 1-2″ off the ground. Be sure the storage area is well
ventilated. Cover the machine with a genuine Polaris ATV cover. NOTE:
Do not use plastic or coated materials. They do not allow enough
ventilation to prevent condensation, and may promote corrosion and
oxidation.
Do not start the engine during the storage period. This will disturb the
protective film created by fogging.
CAUTION
To Next Page
Loading...
Need help?
General
