58
CONTROLS AND FEATURES
Features
Rider Information Center
The rider information center has 4 standard modes:
Mode 1 - Odometer
Mode 2 - Tripmeter
Mode 3 - Total Service Hours
Mode 4 - Programmable service interval
The reverse override button which is found on the LH handlebar is also
the “mode button”. NOTE: If using the mode button to program the
rider information center, or to toggle through the options, the machine
cannot be in reverse.
Mode 1 - Odometer
This will record the amount of miles the ATV travels.
Mode 2 -Trip Meter
To reset the trip meter, select the tripmeter mode. Press and hold the
mode button (override button) until the total changes to “0” . NOTE:
In the Rider Information Center, the trip meter is displayed with a
decimal point, the odometer is displayed without a decimal point.
Mode 3 - Hour Meter
This mode logs the total hours the engine has been in operation.
To Next Page
Loading...
Need help?
General
