90
MAINTENANCE AND LUBRICATION
Lubrication Recommendations
(8) Front
Drive Axle (U
Joint) (AWD
Models)
Grease+ Locate grease fitting and
grease with grease gun.
Every 3
months or
50 hours
(9) Ball Joint
Grease
**
Locate fitting on back side of
struts and grease with grease
gun.
Every 3
months or
50 hours
(10) Front A
Arm Pivot
Shaft
Grease
**∆
Locate fitting on pivot shaft
and grease with grease gun.
Every 3
months or
50 hours
(11) Upper
steering Post
Bushing
Grease
**
Locate fitting on steering post
and grease with grease gun.
Every 3
months or
50 hours
(12) Upper
Control Arms
Grease
**∆
Locate fittings and grease Semi-
annually
(13) Lower
Control Arms
Grease
**∆
Locate fittings and grease Semi-
annually
(14) Rear
Wheel Hub
Bearing Carri-
er
Grease
**∆
Locate fitting and grease Semi-
annually
(15) Rear
Anti-Roll Bar
Grease
Locate fitting and grease Semi-
annually
More often under severe use, such as wet or dusty conditions.
**Polaris Premium all Season Grease or grease conforming to NLGI
No. 2, such as Conoco Superlube M or Mobilegrease Special.
+ Grease every 500 miles, or before long periods of storage or after
pressure washing, or after submerging in water. Always use Polaris
Premium U-Joint Lube for maximum service of these driveline
components (PN 2871515 3 oz.)(PN 2871551 14 oz.).
∆ When suspension action becomes stiff or after washing.
NOTE: Hours are based on 10 mph average.
To Next Page
Loading...
Need help?
General
