EasyManuals Logo

Polaris Trail Boss 330 User Manual

Polaris Trail Boss 330
129 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #96 background imageLoading...
Page #96 background image
92
MAINTENANCE
Battery
Battery Installation
Using a new battery that has not been fully charged can damage the bat-
tery and result in a shorter life. It can also hinder vehicle performance.
Follow the battery charging instructions on page 94 before installing the
battery.
1. Ensure that the battery is fully charged.
2. Place the battery in the battery holder in the rear cab.
3. With conventional batteries, install the battery vent tube (sealed bat-
teries do not have a vent tube). The vent tube must be free of
obstructions and securely installed. Route the tube away from the
frame and vehicle body to prevent contact with electrolyte.
WARNING! Battery gases could accumulate in an improperly installed vent tube
and cause an explosion, resulting in serious injury or death. Always ensure that
the vent tube is free of obstructions and is securely installed as recommended.
4. On conventional batteries, coat the terminals with dielectric grease
or petroleum jelly.
5. Connect and tighten the red (positive) cable first.
6. Connect and tighten the black (negative) cable last.
7. Secure the battery hold-down strap.
8. Verify that cables are properly routed. Cables should be routed low
so they don’t interfere with safe seat installation.
9. Reinstall the seat.

Table of Contents

Other manuals for Polaris Trail Boss 330

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Polaris Trail Boss 330 and is the answer not in the manual?

Polaris Trail Boss 330 Specifications

General IconGeneral
BrandPolaris
ModelTrail Boss 330
CategoryOffroad Vehicle
LanguageEnglish

Related product manuals