70
MAINTENANCE
Lubrication
Front Suspension
Lubricate the suspension and steering components with Polaris Pre-
mium All-Season Grease at 500 miles (800 km) and annually or every
1000 miles (1600 km) thereafter. See page 109 for the part numbers of
Polaris products.
The illustration shows the location of suspension and steering compo-
nents. A + indicates a grease point or fitting.
• Grease the left and right spindles. Raise the front end of the machine
to permit better grease entry into the spindle area.
• Lubricate both of the front ski pivots at the fittings as shown.
• Grease the driveshaft clutch side bearing.
• Use an aerosol lubricant on the steering post support bracket.
• Grease the center steering arms.
• Grease the steering post lower pivot.
• Grease the rear suspension pivot shafts (raise the rear of unit).
A grease gun kit, complete with grease and adaptors, is available to
lubricate all fittings on Polaris snowmobiles. See page 109.
To Next Page
Loading...
Need help?
General
