TRACK
REMOVAL
Your
1973
TX
Starfire
is
equipped
with
a
quick
change
front
drive shaft. This unique system
was
developed
for
two
very
important
reasons:
1.
It
is
extremely fast
to
change tracks
...
approxi-
mately ten minutes
from
start
to
finish.
2.
The chaincase, gearing, and driven
clutch
do
not
have
to
be
removed.
Without
having
to
remove any
of
these items,
your
clutch alignment and center
distance
will
not
change.
To remove
track:
(See
opposite
page)
NOTE:
Leave
chaincase
as
is!
It
is
not
necessary
to
remove
cover, chain
or
gears.
1.
Remove slide rail.
2. Loosen
front
drive shaft bearing lock collar.
3.
Loosen
only
the
bottom
two
(2) bearing flangette
supporting bolts (do
not
remove).
4.
Slide
front
shaft
from
splines in stationary hub
mounted
to
the chaincase.
5.
Pivot
front
drive shaft and bearing in flangette.
6.
Slide
front
shaft
from
bearing and remove shaft and
track.
7.
To
reinstall, reverse the above procedure.
8.
Check track alignment and tension.
NOTE:
When tightening bearing lock collar,
tighten
with
the
rotation
of
the
front
drive shaft.
22
To Next Page
Loading...
