45
OPERATION
Starting the Engine
NOTICE: Engaging the starter when the engine is running WILL result
in serious engine damage, especially if the transmission is in
reverse. Never engage the starter when the engine is running.
1. Turn the fuel valve on. See
page 27.
2. Turn the key to the ON
position.
3. Pull the engine stop switch
up to the RUN position.
4. If starting a cold engine,
flip the choke toggle to
FULL CHOKE. Do not
use the choke if starting a
warm engine.
NOTE: Do not depress the throttle until the engine starts.
5. If equipped with electric start, turn the key to START to crank the
engine. Release the key to the ON position when the engine starts.
NOTICE: Don’t pull the starter rope to the fully extended position and
don’t allow it to snap back into the housing. Damage may
result. To avoid engine damage, do not operate the electric
starter or pull-rope starter while the engine is running.
6. If not equipped with electric start, grasp starter handle and pull
slowly until the recoil engages; then pull abruptly to crank the
engine.
7. Repeat the cranking procedure as needed until the engine starts.
8. After the engine starts, flip the choke toggle to the OFF position. If
the engine slows or wants to stop, use intermittent choking to the
HALF CHOKE position.
To Next Page
Loading...
Need help?
General
