95
MAINTENANCE
Steering System
n Ski Skags
Check skags weekly to maintain positive steering characteristics. Skags
must be replaced when worn to half their original diameter.
NOTE: Carbide skags must be replaced if any abnormal wear or chip-
ping is found.
Skag Replacement
1. Raise and support the front of the machine so the skis are approxi-
mately 6I (15.2 cm) from the ground.
2. Remove the attaching hardware and pry the skag downward.
3. Remove the rear end of the skag.
4. Remove the front end of the skag.
5. Reverse the steps to install a skag.
WARNING
Worn skis and/or skags will adversely affect handling. Loss of vehicle control
may result, causing serious injury or death.
See your dealer’s studding chart for recommended skags. If you install
longer or more aggressive carbide skags than the original equipment, it may
also be necessary to add track studs to maintain proper vehicle control while
turning on hard-packed snow or ice.
To Next Page
Loading...
Need help?
General
