- 15 -
TV Function
Preparations
1. After connection, press the POWER button to turn on the power.
2. Press the INPUT button to shift to TV mode. You can go on with the following operations:
Image Setting
Note: This item is only available when there is signal input.
Press the MENU button once to enter the setup
menu, as shown on the right:
In the setup menu, press the #$ button to
select Image and then press the OK button to
enter the item. Press the #$ button to select.
Press the MENU button to return to the previous
menu.
Scheme Setup
Press the #$ button to select Scheme and
press the OK button to enter. Press the
#$button to select the desired item and press
the OK button to confirm your selection. Press
the MENU button to return to the previous menu.
Brightness Setup
Press the #$ button to
select Brightness and press
the !" button to adjust the
value. Press the MENU button
to return to the previous
menu.
To Next Page
Loading...
Need help?
General