Make sure the batteries have been inserted properly into your digital camera.
Use 3x AAA (1.5V) batteries. Alkaline batteries are recommended. Batteries not included.
1) Open the battery compartment door.
2) Insert the batteries according to the battery polarities shown below.
3) Close the battery compartment door securely.
Remove the batteries from the camera when not in use for an extended period.
Do not mix alkaline and non-alkaline batteries.
When the battery power is low the battery icon turns red and the camera will
automatically turn off a few seconds later.
Some features will not work if the battery power level is low.
The energy status of the battery power level is displayed on LCD screen as shown
below:
Full battery power Medium battery power Low battery power
Make sure an SD Memory card has been properly inserted into your camera. SD card not
included. Class 4 SD Memory card or higher is recommended.
To properly insert the SD Card:
1) Push the SD card into the slot in the direction shown on the camera (see SD icon by the SD
card slot).
To Next Page
Loading...
Need help?
General
