14
Preparation of Remote Control
Follow the steps below to install the battery.
1. Pull the battery holder out from the remote control in the direction of the arrow.
2. Load a new battery properly with the (+) sided up.
3. Insert the battery holder back into the remote control.
Battery type: CR2025 3V
Battery service life: approximately 1 year under normal use (at room temperature).
Use of Remote Control
Point the remote control unit to the remote sensor within the range of 16 feet and
angles of 60 degree, and without obstacles between remote control and remote sensor.
Remote Control
Note
¾ Improper use of the battery may cause
overheating, explosion or ignition, which
can result in an injury or a fire. Battery
leakage may damage the remote control.
¾ Do not expose the remote control unit to
direct sunlight.
¾ Do not recharge, disassemble, deform or
heat the battery.
¾ Do not put the battery in fire or water.
¾ Immediately replace the exhausted
battery.
¾ Take out battery when the remote is not in
use for a long time.
To Next Page
Loading...
Need help?
General
