16
17
Any obstacles between the Sound
Bar and the device may reduce the
signal strength. Keep the Sound Bar
and device away from other electrical
devices as they could interfere with
the bluetooth signal.
IMPORTANT: Not all bluetooth
devices will be compatible with the
Sound Bar.
Pairing the Sound Bar with a
bluetooth enabled device
1. Turn the bluetooth function on the
device you wish to pair.
2. Press the button on the
end of the Sound Bar until BT is
shown on the Sound Bar display
or press the BT button on the
remote control. "NO BT" will be
shown on the display if the Sound
Bar is not paired with a devise.
3. Check the found list on your
devise for 'PLA21SB001A' and
connect to it.
4. If the bluetooth connection is
successful the Sound Bar will
give you an audio prompt 'Paired'
and the display on the Sound Bar
will show "BT".
5. To disconnect the device, switch
to another function on the Sound
Bar or Press and hold the ulI or
BT button on the remote control.
The Bluetooth disconnected will
be disconnected when you hear a
audible prompt.
Tips on using the bluetooth
function
• If requested, enter the password
0000.
• If no other Bluetooth device
pairs with this player within two
minutes, the player will recover its
previous connection.
• The device will also be
disconnected if you move out of
the range of the Sound Bar.
• If you want to reconnect, move
closer to the Sound Bar. Note:
Check the bluetooth list on the
device to ensure the Sound Bar is
still connected.
• If the connection is lost, reconnect
following the instructions for pairing
the Sound Bar.
Listening to music
If the connected Bluetooth device
supports Advanced Audio Distribution
Profile (A2DP), you can listen to the
music stored on the device through
the player.
If the device also supports Audio Video
Remote Control Profile (AVRCP), you
can use the players remote control to
play music stored on the device.
1. Pair the device with the Sound
Bar.
2. Play music via your device (if it
supports A2DP).
3. Use the supplied remote control
to control playback from the
device (if it supports A2DP).
To pause / resume play, press the
ull button on the remote control.
To skip to a track, press the ltt
/ uuI buttons on the remote
control.
To Next Page
Loading...