5
5
Preparing the remote control
Important battery information:
• When the remote control is not used for a long time (more than a month),
remove the battery to prevent it from leaking.
• If the batteries do leak, wipe away the leakage inside the battery compartment
and replace the batteries with new ones.
• Do not use any batteries other than those specified.
• Do not heat or disassemble batteries. Never throw them in fire or water.
• Do not carry or store batteries with other metallic objects. Doing so could
cause batteries to short circuit, leak or explode.
• Never recharge a battery unless it is a rechargeable type.
IMPORTANT: The remote control will work within a 6m range, however this may be
impossible if there are obstacles between the unit and the control.
If the remote control is used near other devices which generate infrared rays then it
may not operate properly and may interfere with other devices.
Fitting/replacing the batteries:
Push down gently on the top of the battery
cover and slide down off the bottom of the
remote control.
Insert the two AAA batteries into the battery
compartment.
Ensure the + & – on the batteries are
correctly aligned with the marks in the battery
compartment.
Slide the battery compartment cover back onto
the bottom of the remote control as shown in
the diagram and push upwards until it locks in
place.
To Next Page
Loading...