EN-37
White Balance
This sets the white balance for a variety of lighting conditions and adjusts the images
overall color according to the surrounding light conditions. Use this function if image
color appears unnatural.
* Auto / Incand. / Fluoresc.1 / Fluoresc.2 / Daylight / Cloudy / Manual WB
Sharpness
This sets the sharpness of the image that will be captured.
* Hard / Standard / Soft
Color
This sets the overall color of the image that will be captured.
* Standard / Vivid / Color Accent (Red) / Color Accent (Green) / Color Accent (Blue) /
Sepia / B&W / Blue / Red / Green / Yellow / Purple
Saturation
This sets the saturation of the image that will be captured.
* High / Standard / Low
Metering
This sets the metering method for calculating the exposure.
Capture Mode
This sets the recording method at the time of capturing images.
* Center: Averages the light metered from the entire frame, but gives greater weight
to the subject matter at the center.
* Spot: A very small portion of the center of the screen is measured to calculate
the correct exposure.
* Average: The exposure is measured all of the image area.
* Single: Captures one image at a time.
* Continuous: Permits continuous capture of up to 3 images.
* AEB: Permits 3 consecutive images in the order of standard exposure,
underexposure and overexposure compensation.
* Album Shot: Creates an album-like layout to combine 3 shots into a single image.
* Burst Permits continuous photography while pressing and holding the
shutter button. As long as you hold the shutter button pressed,
images are captured until the memory capacity is exhausted.
* Cont.flash Permits continuous capture of up to 3 images with flash.
* Pre-shot Lets you capture the background first, then have someone to capture
you in front of it.
* Coupl.shot Uses separate areas to combine two shots. You can include yourself
in the shot.
To Next Page
Loading...
Need help?
General
