POLLOGEN GENEO+U - Performing Oxygeneo Treatment Procedure; Capsugen; Performing Massage Treatment; Applicator and Massager Head Care and Maintenance

geneo+U 33
PERFORMING OXYGENEO TREATMENT PROCEDURE
Move the applicator in circular and linear movements across the entire area using very mild pressure.
You may also stay for a short while on selected areas to optimize eect. Adjust intensity (increase or
decrease) according to treatment area and patient tolerance and comfort.
CARE AND MAINTENANCE
Ensure the system does not come in contact with water. Make sure the system is completely
dry before next use. After every treatment clean and disinfect the Applicator and Massager
Head according to the following procedure:
1. Disconnect the Massager Head silicone top cover from its plastic base.
2. Clean with water and detergent solution until it is visually clean.
3. Use a soft, dry cloth to dry the massager head.
4. Use a soft cloth, moistened with 70% alcohol available in local pharmacies, to disinfect
the massager head for at least 1 minute.
5. Use a soft, dry cloth to dry the Massager Head.
PERFORMING MASSAGE TREATMENT
Massage the massager head on the skin.
CAPSUGEN
Capsugen contents is 0.01lb. 6 gr. e
Ingredients: Sodium Bicarbonate, Citric Acid, Magnesium Stearate.
Capsugen instructions:
Cleanse the skin thoroughly. Once the skin is clean, massage Capsugen on wet clean skin at least
once a week.