geneo+U
4
CAUTIONS
This is an electrical device. To reduce the risk of serious injury:
• Read this chapter to become familiar with all its safety requirements and operating procedures
prior to System operation.
• Use geneo+U for its intended purpose only, as described in this user manual. The manufacturer
cannot be held responsible for damage or injury resulting from improper or careless use.
• When the geneo+U system is plugged in, never leave it unattended.
• Do not operate, place or store geneo+U near any water source.
•
Do not touch the device should it fall into water. Unplug the power cord immediately with dry hands.
• Before cleaning or maintenance, rst turn the geneo+U OFF, then unplug the power supply
from electrical outlet.
• Do not pull on the power supply cord or the system to unplug the unit from the electrical outlet.
• Switch o the system before moving it.
•
Before connecting the power supply cord, make sure that the ON/OFF switch is in the OFF position.
• Check all connections before plugging in the System’s power supply cord.
• Pay attention to the screen quality that it is OK during the rst few seconds of the system check
(After the geneo+U by Pollogen upload, the touch screen will become white and then black with
Screen Test heading as part of the System’s self-system check.)
• In case of uncertainty regarding potential side eects, have the patients consult their physician
and bring consent for treatment.
• When uploading a program version using a USB plug, in case of wrong or incomplete program
upload, restart the system.
• Patients should remove all jewelry prior to treatment.
• Repairs to geneo+U should only be carried out by an authorized customer service center.
Do not try to repair the system yourself!
• Keep the applicators and device clean. See cleaning instructions in each section.
• Ultrasound - Do not allow the Applicator to come in contact with hard objects that can damage
the Ultrasound electrode.
To Next Page
Loading...
