1. Air outlet grill – cooled air comes out of this outlet. IMPORTANT
– ensure horizontal louvres are open by grasping the top louvre
and pulling downwards. Louvres can be locked in 4 positions
depending on where air needs to be directed. The horizontal
position is recommended.
2. Control panel – controls the functions of the air conditioner
3 Castors – enables the air conditioner to be easily moved
4. Intake – enables air to enter the air conditioner and must
not be blocked
5. Remote control receiver – receive signals from the remote control
and must not be covered.
6. Removable lters – must be cleaned every 2 weeks
7. Handle – used when moving air conditioner
8. Air exhaust hose housing – exhaust hose is connected here
9. Power plug holder – used to store plug after power cord
stored on winding lugs
10. Condensate drain – remove cap to drain water from the
water tank/tray
11. Power cable cord and plug
12. Power cord winding lugs
13. Middle condensate drain – only used when the unit is in
dehumidifying mode
14. Air exhaust hose – approx. 1.5m long fully extended
15. Hose outlet – connects to window slider
16. Hose inlet – connects exhaust hose to rear of unit
17. Window slider – ts in window and hose outlet is attached
18. Remote control
19. Castor locks – put under castors to stop unit rolling
20. Drain pan – ts under unit and is used to catch water
from the water tank/tray
21. Drain hose – used to drain water from the middle
condensate drain
To Next Page
Loading...
